Hardware Example

RS-232 to Profibus-DP Converter for Industrial Weigh Scales

A custom board that bridges six serial weigh scales to a PLC network with isolation and low latency.

Sciotex designed a digital signal conversion device to connect industrial weigh scales to a PLC network. The scales communicate over RS-232 using the manufacturer’s serial command protocol, and the PLC network is Profibus-DP. The device polls and aggregates mass values from six scales at once and passes them to the PLC with high reliability and low latency. The board and firmware were designed in-house.

Designed, Built and Supported in the United States since 1997

Schedule a Free Consultation

Six scales

Polled simultaneously

RS-232 to Profibus-DP

Serial to fieldbus

Galvanic isolation

Between every bus

In-house design

Board and firmware

Example Overview

Bridging Serial Instruments to a PLC Network

Why build a custom protocol converter?

Many instruments, including most industrial weigh scales, still speak RS-232 with their own command sets, while modern plants run on fieldbuses such as Profibus-DP. Off-the-shelf gateways often handle one device, support a generic protocol or add latency, which fails when six scales must report at the same time.

This board polls all six scales in parallel, aggregates the readings and presents them to the PLC as fieldbus data. Galvanic isolation between each RS-232 bus, the Profibus-DP bus and the real-time microcontroller prevents ground loops and protects the electronics in an industrial environment.

Custom RS-232 to Profibus-DP signal converter board
Digital signal converter · designed by Sciotex

At a glance

Inputs
Six weigh scales, RS-232, scale command protocol
Output
Profibus-DP PLC network
Processing
Real-time microcontroller
Isolation
Galvanic isolation between all buses
Design
Custom board and firmware, in-house

Trusted by engineering and quality teams at

Lockheed Martin
L3Harris
Medtronic
NVIDIA
Raytheon
Procter & Gamble

How It Works

How the Signal Converter Works

Six serial conversations become one fast, isolated fieldbus data stream.

1Poll

Each scale is queried over its own RS-232 bus.

2Parse

Mass values are decoded from scale responses.

3Aggregate

Readings are combined in the microcontroller.

4Publish

Data is mapped to Profibus-DP for the PLC.

5Isolate

Every bus stays galvanically isolated.

What the System Does

Hardware Built for the Plant Floor

Reliability and timing mattered more than generic flexibility.

Simultaneous polling

All six scales reported together.

Low latency

Fresh data delivered to the PLC quickly.

Full isolation

Protects against ground loops and noise.

Custom firmware

Written in-house for this application.

Hardware and Software

Device Capabilities

See ground loops and galvanic isolation for why isolation matters here.

Scale interfacesSix RS-232 buses
Scale protocolManufacturer serial command protocol
PLC interfaceProfibus-DP
ControllerReal-time microcontroller
IsolationGalvanic, between all RS-232 buses, Profibus-DP and the controller
DevelopmentCircuit board and firmware designed in-house

Connecting legacy equipment

Custom bridges like this let plants:

  • Keep reliable serial instruments in service
  • Bring their data into PLCs, SCADA and MES
  • Avoid replacing equipment just to change protocols

Need to connect equipment to your network?

Sciotex designs custom interfaces, drivers and protocol bridges for industrial equipment.

Explore factory digital transformation

Additional Resources

Learn More

Connecting Instruments to Your PLC?

Talk to a Sciotex engineer about custom interfaces and protocol bridges.